Contact Us
- A.Yeung@leadmenspacking.com
- +8618933322747
- Building 4, No. 223, Guangcheng Road, Jiuzhouji, Xiaolan Town, Zhongshan City, Guangdong Province
What to Do When the Sealing Film Breaks During Use
The sealing film is running on the machine, and suddenly it breaks. The production line stops, and the operator has to re-thread the film and adjust the machine—anywhere from a few minutes to over ten minutes lost. Film breakage looks like a small issue, but when it happens frequently, it quietly eats away at line efficiency. Drawing on field experience, Leadtra Packaging has put together the common causes of film breakage and how to deal with them.
First, check where it breaks. If it breaks in the heat-sealing zone, it is most likely temperature-related. Too high a temperature locally melts and embrittles the film, so it breaks under tension; too low a temperature means the heat-seal layer doesn't fully melt, and the film tears at the seal under pulling force. If it breaks in the conveying section, it is usually a tension or guide-roller issue. Excessive tension pulls the film too tight; a guide roller that doesn't turn smoothly or has burrs scratches the film, which then breaks. If it breaks at the winding end, it may be improper winding tension settings, or an out-of-round core causing uneven stress.
Then look at the condition of the film itself. Is the end face of the film roll flat? If the end face is uneven, the film will shift side to side during running, and the edges will tear easily under stress. Does the film have pinholes or hidden defects? These defects become the starting point for breakage during operation. In addition, the storage environment is also critical—damp film loses strength, and overly dry film becomes brittle; both increase the risk of breakage.
The troubleshooting approach is: adjust the equipment first, then change the film. If it is a parameter issue, adjusting temperature, tension, and pressure usually improves it. If it is a guide-roller issue, cleaning or replacing the roller will do. If the film still breaks after adjustment, it is advisable to test with another roll of film—seal a few meters with the same parameters and see whether it still breaks. If it works fine after changing the film, the problem lies in the film material itself; if it still breaks, the problem is with the equipment.
Before leaving the factory, Leadtra Packaging conducts breakage testing and tension uniformity inspection on every batch of film to reduce the risk of breakage during use. If your production line experiences frequent film breakage, you can send us the film sample and equipment parameters, and we will help you troubleshoot the cause together.
“Recommend”
【editor】:Leadtra PackagingCopyright:https://www.leadmenspacking.comReproduced please indicate the source









